HWV Heavy Duty Hand Winch manufacturers take you to understand the Installation process of hand winches
Category:
NEWS_bak
Industry news
HWV Heavy Duty Hand Winch
Author:
Source:
Add time:2022-06-21 14:02
1. Install the winch: The HWV Heavy Duty Hand Winch manufacturer tells you that first open the package and take out the winch. Unscrew the hex screw and shim from the end of the gear axe. Fix the nut on the handle to the trapezoidal turbine at the end of the gear axe so that the inside of the nut is close to the friction piece, then tighten the screw and shim.
2. Install the winch wire rope: After The HWV Heavy Duty Hand Winch manufacturer tells you that, loosen the hexagonal screw on the fixing plate on the left side of the winch drum, and take off the fixing plate from the wire rope and the screw with the oval head and the square column. Wind one end of the wire rope clockwise around the reel, and the other end goes through the long, round, arc-shaped hole on the left side of the guardrail.
The HWV Heavy Duty Hand Winch manufacturer tells you that the steel will have an oval head, a square post screw going inside out through the square hole on the left side of the reel. Put it into the wire rope fixing plate, make the wire rope rotate around this screw, pull it back, embed the wire rope in the fixing plate, then tighten it with the hexagon nut, shake the handle, and make the wire rope wind on the reel (when winding the wire rope, keep it in tension).
3. The HWV Heavy Duty Hand Winch manufacturer tells you that Finally, use three screws and nuts to fix the winch to the base. The base can withstand heavy loads.
The above information is HWV Heavy Duty Hand Winch Manufacturer's introduction and analysis of the Installation process of hand winches, hope it helps you.
Contact Us
Mobile: +86-13967667857
Tel: +86-0576-81746110
Fax: +86-0576-81746183
E-mail: shili@patngk.com
Add: Medical Packaging Industrial Zone,Lupu,Yuhuan,Zhejiang,China
